left boarder
Voyager 210/2100/2110/2500v Configuration

Please Note: These are the connection settings for UK Broadband accounts only
  1. Open Internet Explorer (or whatever browser you use to view webpages).
  2. Remove the existing address in the Address Bar
  3. Type in the following IP Address: 192.168.1.1
  4. Press Return/Enter/Go
  5. A BT Voyager screen should come up
  6. On this screen, you should see that it is looking for a Broadband Username and a Broadband Password.
  7. You will need to enter the Broadband User Details which should have already been provided to you.
  8. Enter these details and then click on the
  9. Connect
    10. button.
  10. After a short period of time, the screen should refresh and it should show you details of your Internet Connection (i.e. duration of time connected, etc, etc).
  11. If the screen returns back to showing you the Broadband Username and Broadband Password fields and is telling you that your BT Voyager is ready to connect, then you shall need to carry out the following:
  12. On the left hand side, there is a menu option. You need to click on Advanced
  13. On the Advanced Configuration Screen, click on Advanced again
  14. On the left hand side, you will see that the menu list has expanded.
  15. You need to click on Internet
  16. If prompted for a username and password, enter the following:
  17. Username: admin
  18. Password: admin
  19. Click on OK
  20. On the Internet Configuration screen, click on the Red pencil under the word Edit
  21. You need to make sure that the VPI and VCI settings are
    VPI: 0
    VCI: 38
  22. Click Next
  23. Ensure that PPPoA (PPP over ATM) VC-MUX, is selected on the next screen and click on next
  24. Obtain an IP Address should be automatically should be selected so click on next
  25. Ensure that your Broadband Username and Password details are in place
  26. The Session Established by should be set to Always on and then click on next
  27. Apply the settings and then click on Finish
  28. The router will reboot for 60 seconds and when it finishes, it should have a connection in place
right boarder